The XPS-DRV03 is a fully numerical, programmable PWM-Amplifier that has been optimized for the use with high-performance DC motors. The 100kHz high switching frequency and appropriate filter technologies minimize noise, enabling ultra-precision positioning in the nm-range. The XPS-DRV03 supplies a m..
$575.00
Ex Tax:$575.00
The XPS-DRV02L is a software configurable low-noise amplifier for 3-phase brushless motors. This driver has been optimized to perform with the XM linear motor stages, enabling 1nm MIM performance. The XPS-DRV02L supplies a maximum output current of 2 Amps per phase and 44 Vpp. The XPS-DRV02L require..
$0.00
Ex Tax:$0.00
The XPS-DRV02P is a software configurable low-noise amplifier for 3-phase brushless motors. This driver has been optimized to perform with the XM linear motor stages, enabling 3nm MIM performance. The XPS-DRV02P supplies a maximum output current of 7 Amps per phase and 44 Vpp. The XPS-DRV02P require..
$0.00
Ex Tax:$0.00
The XPS-DRVP1 is an XPS compatible driver card that can drive piezo-stack based NanoPositioning products, with model numbers that end with a '–D'. These NanoPositioners are differentiated with a 25 pin D-sub connector. Like most standard Newport stages, the connector has embedded ESP technology that..
$765.00
Ex Tax:$765.00
The XPS-DRV00 pass-through module can be used to pass control signals to other external third-party amplifiers or drivers. By setting the controller’s dual DAC output to either analog position, analog stepper position, analog velocity, analog voltage or analog acceleration, including sine commutatio..
$219.00
Ex Tax:$219.00
The XPS-DRV02 is a software configurable PWM amplifier for 3-phase brushless motors. This driver has been optimized to perform with the XM and IMS-LM linear motor stages. The XPS-DRV02 supplies a 100 kHz PWM output with a maximum output current of 5 Amps per phase and 44 Vpp. The XPS-DRV02 requires ..
$868.00
Ex Tax:$868.00
The XPS-DRV01 is a software configurable PWM amplifier that is compatible with most of Newport’s and other companies’ DC brush and 2-phase stepper motor positioners. When used with Newport stages, the configuration of the amplifier is easily completed using the auto-configuration utility..
$575.00
Ex Tax:$575.00
The XPS-DRV11 is a software configurable universal digital driver card that has been optimized to perform with the most Newport’s and other companies’ DC brush, Linear and Stepper motor positioners. The XPS-DRV11 can supply PWM output of up to 100 kHz with a maximum output current of 6 A..
$533.00
Ex Tax:$533.00
Showing 1 to 8 of 8 (1 Pages)