The M-PS-1T Table Mount Adaptor allows mounting of PS-series Pedestal Extensions directly to an optical table without a clamp fork. This adaptor is a 25.4 mm high Pedestal Extension Post having an M6 thread on one end and the standard M4 thread on the other; threaded studs included. The M-PS-1T is..
The CC-596H TE Controller Interconnect Cable is designed for use with ILX Lightwave's LDT-5940C or LDT-5900 Series Precision Temperature Controllers and various ILX laser diode mounts. Twisted pair signal wires and braided shielding help minimize noise generation and reception by the cable, which me..
The CC-505S TE Controller/Laser Diode Mount Interconnect Cable is the temperature controller complement to ILX's CC-305S laser current source cable. Twisted pair signal wires and braided shielding help minimize noise generation and reception by the cable, which means less noise in the laser's output..
The CC-516M TE Controller Cable Bundle is a set of eight twisted-pair cables with braided outer shields. The cable composition is identical to ILX's standard CC-505S TE Controller/Laser Diode Mount Interconnect Cable but has a shorter length to accommodate installation in the confined space of an eq..
The CC-550S TE Controller/Laser Diode Mount Interconnect Cable is the temperature controller complement to ILX's CC-355S laser current source cable. Twisted pair signal wires and braided shielding help minimize noise generation and reception by the cable, which means less noise in the lasers output...
The CC-595S TE Controller/Laser Diode Mount Interconnect Cable is designed to interface between ILX Lightwave's LDT-5940C and LDT-5900 series Precision Temperature Controllers and Laser Diode Mounting Fixtures. Twisted pair signal wires and braided shielding help minimize noise generation and recept..
The CC-501HT TE Interconnect Cable is designed for use with most of ILX Lightwave's precision temperature controllers and high power mounts. Twisted pair signal wires and braided shielding help minimize noise generation and reception by the cable, which means less noise in the laser's output...
The 300-04 Temperature Controller Cable (length 6 ft.) is for 350B and 6100. A DB15 Male connector on one side connects to a 300B or 6100. A DB15 Female connector on the other end connects to Newport's low power laser diode mounts with temperature control...
The 3150-04 Temperature Controller Cable has a D-Sub 7W2 Male connector on one end that connects to a 3150 or 3700 high power temperature controller. A D-Sub 7W2 Female connector on the other end of this 6 foot cable connects to Newport's legacy high power laser diode mounts. For a cable with bar..
The TR-8Q20-10 Thread Adaptor converts an 1/4-20 threaded hole to an 8-32 threaded hole. These thread reducers are extra short (only 1/4 in., 6.4 mm) which allows them to be fully inserted in shallow threaded holes where other longer thread adaptors will bottom out and protrude. To assist in insta..
The TR-M4Q20-10 Thread Adaptor converts an 1/4-20 threaded hole to an M4 threaded hole. These thread reducers are extra short (only 1/4 in., 6.4 mm) which allows them to be fully inserted in shallow threaded holes where other longer thread adaptors will bottom out and protrude. To assist in instal..
The TR-E2E8-10 Thread Adaptor converts an 8-32 threaded hole to a 2-56 threaded hole. These thread reducers can be used for general purpose needs but are specifically intended to allow post mounting of the New Focus Brand Tiny Mounts. To assist in installation and removal, each thread reducer has a ..